Produttore chimico di alta qualità
Hotline nazionale di consultazione:+86 021-64208466
Posizione attuale:Casa > Prodotti > prodotti chimici > Additivi chimici >

Photoinitiator MBF CAS:15206-55-0

15206-55-0 - Names and IdentifiersNameMethyl benzoylformateSynonymsMBFPI-MBFSyna 468IHT-PI MBFD

Email: info@standard-groups.com

Contenuto

15206-55-0 - Names and Identifiers

NomeMethyl benzoylformate
SinonimiMBF
PI-MBF
Syna 468
IHT-PI MBF
Darocur MBF
Photoinitiator-MBF
photo sensitizer MBF
Methyl benzoylformate
Methyl benzoyl formate
Methyl phenylglyoxylate
methyl oxo(phenyl)acetate
Methyl-α-oxo-phenylacetate
Phenylglyoxylic acid methyl ester
Glycopyrronium Bromide EP Impurity H
alpha-oxo-benzeneaceticacimethylester
alpha-Oxobenzeneacetic acid methyl ester
Benzeneaceticacid,.alpha.-oxo-,methylester
Glycopyrronium Bromide Impuritiy 3 (Methyl benzoylformate)
CAS15206-55-0
EINECS239-263-3
InChIInChI=1/C9H8O3/c1-12-9(11)8(10)7-5-3-2-4-6-7/h2-6H,1H3

15206-55-0 - Physico-chemical Properties

Formula molecolareC9H8O3
massa molare164.16
Densità1.155 g/mL at 25 °C (lit.)
Punto di fusione16°C
punto Boling246-248 °C (lit.)
Punto Flash> 230 ° F
Solubilità in acqua2g/L at 20℃
AspettoLiquido
Gravità specifica1.161.155
ColoreClear yellow
BRN1100868
Condizioni di conservazioneStore below +30°C.
Indice di rifrattivitàn20/D 1.528
Proprietà fisiche e chimicheDensity 1.155
boiling point 246-248°C
refractive index 1.525-1.527

15206-55-0 - Risk and Safety

Descrizione della sicurezza24/25 - Evitare il contatto con la pelle e gli occhi.
WGK Germania1
Codice HS29183000
TossicitàLD50 orally in Rabbit: > 5000 mg/kg LD50 dermal Rat > 5000 mg/kg

15206-55-0 - Reference Information

LogP1.9 at 23℃
preparation of benzoyl formic acidhydrolysis of methyl benzoyl formate to give good quality benzoyl formic acid
gas chromatographic analysis of 2, 4-dichloro-5-aminophenyl isopropyl etherwith 2.5% OV-210, 2M stainless steel packed column, with methyl benzoylformate as internal standard, at 145 ℃ column temperature, 2, 4-dichloro-5-aminophenyl isopropyl ether and 2, A mixture of 4-dichloro-5-nitrophenyl isopropyl ether was quantitatively analyzed. The coefficient of variation was 0.22% and 0.23%, the average recovery was 99.96% and 100.07%, the linear correlation coefficient was 0.9999.
Utilizzomethyl benzoylformate is an intermediate of the herbicide buprozin.
used in organic synthesis.
UV-curable coatings and inks
metodo di produzioneobtained by esterification of benzoyl acid with methanol. Cyclomethanol and benzoylformic acid were added to the reaction pot, and sulfuric acid was added slowly with stirring. After heating to reflux for 12h, excess methanol was recovered. The esterification was neutralized with dilute sodium carbonate solution, the oil layer was separated, and the water layer was extracted with benzene. The extract was combined with the oil layer, dried over anhydrous sodium sulfate, and then distilled. The solvent benzene was recovered first, and then the low boiling matter was distilled off under reduced pressure. Then the 137-146 ° C. (2.4kPa) fraction was collected and taken as methyl benzoylformate. The raw material benzoylformic acid used was obtained by oxidation of styrene (see 04960), and the yield of esterification based on benzoylformic acid was more than 50%.
The preparation method is to add sodium chloride and sulfuric acid in the reaction bottle, stir at room temperature, Dropwise add benzoyl nitrile, control the temperature at about 30 ℃, and keep the heat for 3 h after dropping, then methanol was added dropwise, and the temperature was raised and refluxed for 5 h. After the reaction was completed, methanol was removed under reduced pressure to obtain a finished product.
temperatura di combustione spontanea>500°C


Disclaimer: Il contenuto di cui sopra è per riferimento e comunicazione solo tra addetti ai lavori del settore e non garantisce la sua accuratezza o completezza. Secondo le leggi e i regolamenti pertinenti e i regolamenti di questo sito web, le unità o le persone fisiche che acquistano articoli correlati devono ottenere qualifiche e condizioni di qualificazione valide.


Messaggio online

Dettagli di contatto

Telefono aziendale

+86-21-6420 0566

Orario di lavoro

Da lunedì a venerdì

Telefono cellulare:

13816217984

Posta elettronica:

info@qinsun-lab.com

Codice QR